Rite-Ride 2264 - Manual

2264
21-8231 11-07 NAD-31350-3
I
NSTALLATION INSTRUCTIONS
Congratulations - your new Air Helper Springs are quality
products capable of improving the handling and comfort of
your vehicle. As with all products, proper installation is the
key to obtaining all of the benefits your kit is capable of
delivering. Please take a few minutes to read through the
instructions to identify the components and learn where
and how they are used. It is a good idea to start by comparing
the parts in your kit with the parts list below.
The heart of the air helper spring kit is, of course, the air
springs. Remember that the air helper springs must flex and
expand during operation, so be sure that there is enough
clearance to do so without rubbing against any other part of the
vehicle.
Be sure to take all applicable safety precautions during the
installation of the kit. The instructions listed in this brochure
and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simply follow the
same procedures.
This kit includes inflation valves and air lines for each air
spring. This will allow you to compensate for unbalanced
loads. If you would rather have a single inflation valve system
to provide equal pressure to both air springs, your dealer can
supply the optional "T" fitting.
I
MPORTANT
!
For your safety and to prevent possible damage to your
vehicle, do not exceed the maximum load recommended by
the vehicle manufacturer (GVWR). Although your Air Helper
Springs are rated at a maximum inflation pressure of 100
P.S.I., this pressure may allow you to carry too great a load
on some vehicles. It is best to have your vehicle weighed
once it is completely loaded and compare that weight to the
maximum allowed. Check your vehicle owner’s manual or
data plate on driver's side door for maximum loads listed
for your vehicle.
When inflating your Air Helper Springs, add air pressure
in small quantities, checking pressure frequently during
inflation. The air spring requires much less air volume
than a tire and, therefore, inflates much quicker.
T
OOLS
R
EQUIRED
• (2) 9/16" E
ND
W
RENCHES
• E
LECTRIC
D
RILL
• (2) 1/2" E
ND
W
RENCHES
• 5/16" D
RILL
B
IT
• U
TILITY
K
NIFE
• 3/8" D
RILL
B
IT
WARNING:
Do not inflate this assembly when it is unrestricted.
The assembly must be restricted by the suspension or
other adequate structure. Do not inflate beyond 100
P.S.I. Improper use or over inflation may cause property
damage or severe personal injury.
267C AIR SPRING 6781 2
UPPER BRACKETS 5318 2
LOWER BRACKETS 5092 2
BRACKET STRAP/SHIM 1/2" 5086 4
BRACKET STRAP/SHIM 1" 5093 4
BRAKE LINE BRACKET 1
AIR LINE TUBING 1
3/8"-16 FLANGE LOCK NUT 21
3/8"-16 X 3/4" FLANGE HEX BOLT 2
3/8"-16 X 1" HEX HEAD BOLT 1
3/8"-16 x 7" CARRIAGE BOLTS 8
3/8" FLAT WASHER 12
3/8"-16 X 1 1/2 HEX BOLTS 8
5/16" FLAT WASHER 4
INFLATION VALVE 2
ELBOW FITTING 2
THERMAL SLEEVE 2
NYLON TIE 6
CAUTION TAG 2
P
ARTS LIST
Installation of this kit requires a minimum of
7-1/2" of clearance between the tire side wall
and the frame.
This kit will not fit the 1997-03 Ford F-150 & 250 light
duty pickups under 8500 GVWR.