Revel Voice - Manual (Page 10)

Figure 8. How to connect the
VOICE speaker in a vertical
bi-amplified system.
SPEAKER CONNECTIONS
(CONTINUED)
BI-AMPLIFIED SYSTEM CONNECTIONS
You can connect the VOICE speaker in either a vertical or hori-
zontal bi-amplified system without requiring an additional elec-
tronic crossover.
VERTICAL BI-AMPLIFIED SYSTEM
Using two identical amplifier channels, remove the shorting straps
from the rear panel; then connect the VOICE speaker, as shown in
Figure 8.
CAUTION: Failure to remove the shorting straps when bi-
amplifying may damage some amplifiers.
NOTE: When using two dissimilar amplifiers, connect the VOICE
speaker in a horizontal bi-amplified system (see the next section).
VOICE Speaker
Owner’s Manual
10
VOICE Rear
Install straps for single-wired operation Note:
Remove straps
for bi-wired
or bi-amplified
operation
Install straps for single-wired operation
Low Frequency Input High Frequency Input High Frequency Level (dB)
0 +.5 -.5 +1 -1
Placement
Compensation
(See Owner's Manual)
Serial Number
Revel Corporation
Chatsworth, California
Made in U.S.A.
On Top Of
Monitor Flush Mounted Stand
Mounted
Amplifier
(rear)
Ch. 1 Ch. 2
(“Y” Adaptor)
INPUT INPUT
Multi-Channel Controller
(rear)
CENTER OUTPUT
white red
Connector Panel
Shorting
Straps
Removed
Low Frequency Input High Frequency Input
High Frequency
Level (dB)
0 +.5 -.5
+1 -1
On Top Of Monitor
Flush
Mounted
Stand
Mounted
Placement
Compensation
(See Owner's Manual)
Serial Number
xxxx