Revel I30 Back Box - Manual (Page 9)

9
REVEL I20/I30 Back Box
Installation Instructions
6. Place the section of drywall over the
back box.With tape measure and pen-
cil, carefully measure and mark where
to position the wall template (included
with the loudspeaker) by using the
measurements recorded in Step 1.
7. Use the wall template to trace where to
cut the drywall.
8. Cut a small hole in the center of the
template area to make sure the
template is in the right location.
9. After confirming the correct location,
cut the template hole opening as
shown in Figure 6 (below). Use a
carpenter’s level to ensure the opening
is level.
10. Fasten the drywall to the wall studs
using drywall screws.
11. Install the speaker mounting frame
into the wall opening. Refer to the
Revel I20/I30 In-Wall Loudspeaker
Owner’s Manual for complete instruc-
tions.
12. The back box’s banana plugs are locat-
ed inside the terminal cup as shown in
illustration A in Figure 7 (above).
Route wires from terminal cup behind
the speaker frame clamps (to prevent
close proximity with the woofer basket)
until they emerge at the top of the
speaker frame as shown in Figure 8
(below). The banana plugs must be
positioned correctly for a proper
connection. Be sure to avoid contact
with the speaker cone.
Figure 6: Cut Opening in Drywall
Interior of Back Box
Terminal Cup
Back Box Banana
Plug Connectors
Back Box
Binding Posts
Back Box Side View
A
Figure 7: Back Box Terminal Cup Banana Plugs
Figure 8: Route Terminal Cup Wires to top of the
Loudspeaker