Revel IC6T2 - Manual (Page 9)

Paint Shield
9 Revel Concerta IW65/IW80 & IC65/IC80/IC6T2
Owner’s Manual
4. Connect the speaker wires to the speaker. Ensure
that the polarity of each connection is correct.
5. Ensure that all four locking tabs are properly
positioned against the locking-tab stops, located on
the speaker frame.
Carefully place the frame assembly into the wall,
ensuring that there is no more than 1/8" play
between the frame and the wall cutout.
After positioning the speaker into the mounting location,
back each screw out one full turn counterclockwise.
6. Screw down each of
the four Phillips-head
screws, alternating
between the four
screws.
The locking tabs will
swivel into place
and secure the unit
to the rear surface
of the wall panel.
Hand-tighten with a nonpowered, straight-handle
Phillips-head screwdriver only. Ensure that the
speaker is securely held in place and that all four
locking tabs are firmly resting against the wall panel.
Note:
Do not use a socket wrench, powered
screwdriver, drill or any other powered tool.
7. Attach the metal grille
and logo.
INSTALLATION
IC65/IC80/IC6T2 IN-CEILING
To add the IC65/IC80/IC6T2 in-ceiling loudspeakers
to finished construction, proceed with the following
instructions.
CAUTION!
Ensure that all audio-system
power is off before beginning
the installation.
1. Remove the plastic
paint shield from the
speaker frame.
2. Determine the correct
speaker location and use
the template included in
the packing materials to
mark the ceiling.
Always allow at least a
1/2" between the ceiling
rafters and the speaker
cutout, or the locking tabs will not have the space to
swivel into place.
3. Ensure that the drywall, plywood or other appropriate
ceiling material is at least a 1/2" thick and capable of
withstanding the weight of the speaker being installed.
Locking Tab
Template
≥ 1/2"
≥ 1/2"
≥ 1/2"