Reloop RMP-2 MK2 LTD. - Manual (Page 25)

6. Folder Search buttons
If an MP3-CD is divided into folders, change directly into these folders using
the Folder Search buttons -6-.
7. Time button
Use the Time button to change between three time modes:
I) Time passed of a track (no separate indication on display)
II) Remaining time of a track (display reads "Remain")
III) Remaining time of entire CD (display reads "Total Remain")
NOTE:
Press the Time button -7- and the Track Wheel -4- simultaneously to access
the pre-set menu. Turn the Track Wheel to select a desired menu item. Press
to access the respective sub-menu. To exit the pre-set menu, press the Time
button -7- again. Select from the following menu items:
1. Version: Firmware information
2. Sleep: Set the stand-by time from 0 - 120 min. (0 min. = inactive)
3. Stop Time: Set the time interval from 0.5 - 20 sec. when the track will
pass the display again
4. Run Time: Set the running speed of the tracks showing on the display
from 20 mSec. - 1000 mSec.
5. Sensitivity: Sensitivity setting of the top section of the Jog Wheel from -
20 to + 20
6. Defaults: Yes = Reset factory settings; Exit = Exit without resetting to
factory settings;
7. Save: Yes = Save the settings made; Exit = Exit the menu without saving
the settings made;
8. Single / Continue button
Use the Single/Continue button -8- to select two different play modes:
I) Single
The current title is played; the player then goes into Pause mode.
II) Continue
The entire CD will be played until you stop it or power is interrupted.
NOTE:
Deactivate the "Auto-Cue" mode by pressing and holding the
Single/Continue button for two seconds. Press the same buttons slightly
longer to activate them again.
For more information regarding the "Auto-Cue" mode go to item 2.
25
ENGLISH
IM_RMP2_MK2.qxp 14.01.2009 15:23 Uhr Seite 25