Reloop TERMINAL MIX 8 - VirtualDJ 8 Operation Guide - Manual (Page 8)

VirtualDJ 8 – Reloop Terminal Mix 8 8
Slicer & Slicer Hold mode
Press the SLICE mode button to set the PADs to SLICER mode.
The eight pads represent eight sequential
beats
—"Slices"—in the Beat Grid. The playing
Slice is represented by the currently red lit pad.
The red light will "move through the pads" as it
progresses through each eight-Slice phrase.
Press a pad to repeat that Slice (hold it down if
you want to keep looping it).
Once the Pad is released the track will continue
to play from the position it would have been if the
pad was never pressed.
If the SLICER mode is selected, press again the same Mode button to set the PADs to
SLICER HOLD mode. In this mode the Slice is memorized on first press as the track
continues to play. (HOLD mode). In this mode the playing Slice is represented by the
currently green lit pad.
In both modes, press and hold SHIFT to receive
the parameters of the Slicer.
Use Pads 1 and 5 to increase/decrease the step
of the Slicer.
Use Pads 4 and 8 to increase/decrease the
length of the applied loop on the slice.
Pads 2, 3, 6 and 7 are not used.
Sampler mode
Press the SMPL mode button to set the PADs to SAMPLER mode.
Each one of the pads triggers a sample from
the selected Sampler Bank of VirtualDJ. If a
bank has less than 9 samples, both sides of
the Terminal Mix 8 will control the same
samples. If a bank has more than 8 samples,
the left side of the Terminal Mix 8 will control
samples 1 to 8 and the right side samples 9 to
16. Each one of the Pads will automatically get
the assigned color of each sample.
Press the pads to trigger a sample.
Depending on the selected trigger mode, use