Reloop BEATPAD - VirtualDJ 8 Operation Guide - Manual (Page 9)

VirtualDJ 8 – Reloop Beatpad 9
C. EFFECTS & LOOPS
24. FX ON. Use this button to
enable/disable the selected effect.
Hold SHIFT down and then use the
left FXON button to trigger the
selected Video Transition and the
right FXON button to trigger the
selected Master Video Effect.
25. FX SELECT. Use this encoder to select an Effect for this deck. Push the encoder to
open/close the GUI of the selected effect.
Hold SHIFT down and then use the left FX SELECT encoder to select a Video
Transition and the right FX SELECT encoder to select a Master Video Effect.
Hold SHIFT down and then push the left encoder to open/close the GUI of the
selected Video Transition and the right encoder to open/close the GUI of the
selected Master Video Effect.
26. FX PARAM. Use this knob to control the 1
st
parameter of the selected effect. Hold
SHIFT down and use this knob to control the 2
nd
parameter of the selected effect.
27. FILTER. Use this knob to apply a Low Pass/High Pass Filter to the deck. In middle
position no Filter is applied.
Hold SHIFT down and use this knob to adjust the key of the track. In middle position
the track will have its original value.
28. LOOP SIZE. Turn the encoder anti-clockwise to half the size of the loop and
clockwise to double it. Hold SHIFT down and then use the encoder to move the
triggered loop forward or backwards by 1 beat.
Push the encoder to trigger the selected size loop. Hold SHIFT down and then push
the encoder to toggle between normal and Roll Loop mode.
29. LOOP. Press this button to trigger a loop of the selected size (toggle function).
When Roll loop mode is selected, the button will apply a temporary (while pressed)
Loop Roll and the track will return to the position it would have been if the Loop was
never triggered.
D. PADS
The 4 Performance Pads (31) offer 4 different modes, depending on the PAD MODE
buttons (30).