Reloop BEATPAD - VirtualDJ 8 Operation Guide - Manual (Page 10)

VirtualDJ 8 – Reloop Beatpad 10
HotCues mode
Press the CUE mode button to set the PADs to HOT CUE mode.
Each one of the 4 pads assigns a Hot Cue
Point (1 to 4) or returns the track to that Hot
Cue Point.
When a Hot Cue Button is unlit, you can
assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is
assigned, the Hot Cue Button will light up
blue.
Hold SHIFT and then press a pad to delete its assigned Hot Cue Point.
Bounce Loop (Roll) mode
Press the BOUNCE LOOP mode button to set the PADs to Loop Roll mode.
Press (and keep down) any of the 4 pads
to trigger a momentary Loop Roll of a
different size (in beats) as per the image.
Once the PAD is released the track will
continue to play from the position it would
have been if the Loop Roll was never
triggered.
The size of the applied Loop Roll can be adjusted with the LOOP SIZE (28) encoder as well.
Instant FX mode
Press the INSTANT FX mode button to set the PADs to Effects mode.
Press (and keep down) any of the 4 pads to
apply a momentary Effect (Beat Grid,
Flanger, Reverb or Backspin) as per the
image.
The parameters of these effects can be
adjusted from the FX PARAM knob (26).