Reloop BEATPAD - VirtualDJ 8 Operation Guide - Manual (Page 8)

VirtualDJ 8 – Reloop Beatpad 8
To continue playback without returning to the Temporary Cue Point, press and hold
the Cue Button, then press and hold the Play Button (15) and then release both
buttons.
Hold SHIFT down and then press this button to stop the track with a gradual brake
effect.
17. SET CUE. This button has the same functionality as the JUMP CUE (16) with the
difference that the deck will stop to the Cue point if the deck is playing.
Hold SHIFT down and then press this button to enable/disable Master Tempo (Key-
lock)
18. SYNC. Press this button to automatically match the corresponding Deck's tempo with
the opposite Deck's tempo and phase.
Hold SHIFT down and then press this button to return and stop the deck at the
beginning of the track.
19. JOGWHEEL. Touch sensitive platter for scratching (SCRATCH mode), bending (CD
Mode) or Seek mode. In Scratch mode, use the jogwheel to scratch and the outer
ring to bend. If the JOG SEEK mode is enabled use the jogwheel to navigate through
the track (seek mode)
The jogwheel offers multi-color leds, which will show the playing marker, the song
progress bar (in SEEK mode), and other colored combinations depending on the
applied effect, loop, loop roll or Filter.
20. PITCH BEND Use these buttons temporary slow-down/speed up the tempo of the
track. Once the buttons are released the track will continue to play at the tempo
designated by the pitch fader.
Hold SHIFT down and then use these buttons to jump 1 beat backwards or
forward (Beat Jump)
21. PITCH. Controls the track's playback tempo. The red led indicates that the pitch
fader of the unit is on zero (center) position
22. JOG SCRATCH. Use this button to toggle between the Scratch (Vinyl) and Bend
(CD) Jogwheel mode.
23. JOG SEEK. Use this button to set the Jogwheel to SEEK mode. If the Seek mode is
enabled, use the jogwheel to fast seek through the track.