RCBS Tube Pistol Bullet Feeder - Manual (Page 4)

UNPACKING
Refer to the list below to Identify parts as you unpack
your new RCBS Tube Pistol Bullet Feeder.
1. Bullet Guide
2. Bullet Feed Die Body
3. Tension Band (2)
4. Bullet Fingers (2)
5. Retaining Ring
INSTALLATION
Install the Tension Band down to the first “step” on
the plastic Bullet Fingers, as shown below, and insert
into the bottom of the Bullet Die. Secure with the
Retaining Ring.
Bullet Fingers are coded on the bottom with a series
of marks (lines):
One = 45 ACP
Two = 10mm/40 S&W
Three = 380/9mm/38
Four = 38/357 Long, 170 gr and heavier
(2) 10mm/40 S&W (4) 38/357 Long
(1) 45 ACP (3) 9mm/38
6. Die Body lock Ring
7. Clear Feed Tube (2)
8. Tube Caps (4)
9. Small Tube Bushing (38/9mm only)
4