Nipros DC-C40M05 - Manual

DC-C40M05 CAMTAP to 4-pin XLR
DC Cable for HDS-300
For using DC-C40M05.
Before operating your DC-C40M05, please read this manual thoroughly and keep it for future reference.
Operating
Instructions
■Features
・ Connecting to the CAMTAP connector of the HDS-300, outputs the DC power from XLR 4-pin connector.
■Outsideview and Dimensions
■Specifications
Connector
Cable Length
1 XLR 4-pin connector, right-angle, female
1 CAM-Tap connector, male
0.4 m
Specifications
CAMTAP connector 4-pin XLR connector
0.4 m
NOTE Features, design and specifications are subject to change without notice.
NIPROS accept no liability whatever for damages arising from improper use not conforming to the
instructions in the instruction manuals.
NIPROS accept no liability whatever for incidental damages arising out of the use or inability to use
the product, including, but not limited to, damage to the camera, etc., corruption or loss of data, lost
business revenue or suspension of business operations.
4-pin XLR connector
1
2
3
4 DC12V(G)
NC
NC
DC12V(＋)
DC power output
XLR 4-pin (female)
1
2 3
4
NOTE How to adjust the orientation of cable outlet.
The orientation of the cable outlet of right-angle XLR connector can be adjusted appropriately
according to the location of the connector connectoed,
CAMTAP connector 4-pin XLR connector
∼∼
CAMTAP 2
B
0
45
90
-45
-90
A
1.Loosen and slide
the cable boot A
(bushing).
2.Remove the cover
B .
3.Adjust the orientation
of the cable outlet by
turning the housing.
A
B
4.Position the cover B
and tighten the boot A .
cable boot
(bushing)
cover
housing
cable outlet
cover
cable boot
(bushing)
Adjust
TM