Nipros FS-40X - Manual (Page 14)

4 ch Field Mixer FS-40X
Use
14
Input Signal Setting
Before connecting the input signals, select and set the input select switches.
Select the input connector to which the input signal will be input according to the mixing channel
and the output connector.
■Input Select Switch Setting and Input Signal Connection
LINE : When connecting the LINE level signal.
P48 : When connecting a phantom 48 V condenser microphone.
AB12 : When connecting a A-B 12 V type microphone.
(ex. SENNHEISER MKH416T, etc.)
D-MIC : When connecting a dynamic microphone
that does not need a power supply.
BATTERY CASE
Set the input select switch
Input connector
Input signal
XLR 3-pin female
2PIN:HOT 1PIN:GND
3PIN:COLD
1PIN:GND 2PIN:HOT
3PIN:COLD
XLR 3-pin male
1． Set the input select switch according to the input signal.
2． After setting the input select switches, connect the input signals to each of the input connectors
by the XLR 3-pin cable.
Input select switches
Input connectors （XLR 3-pin）
Input Connector Pinassignment
FS-40X A type
FS-40X B type