Nipros HDP-2000 - Manual (Page 15)

15
HD-SDI IN HD-SDI OUT TALLY HDMI PC IN VBS IN PB IN PO WER DC IN OFF ON 1 GND 4 +12V
HD-SDI IN HD -SDI OUT TA LLY H DMI PC IN VBS IN PB I N P OWER DC IN OFF O N 1 G ND 4 +12V
9. Fit the shading cover in the tip of the lens, and tighten the drawstring to close the
opening of the shading cover.
8. Unlock the fastening in front of the main body, and open the top board.
7. Mount the camera to the tripod base on the camera plinth.
And, loosen the cramps, slide the camera forward or backward until it is in
the appropriate position, and tighten the cramps.
Caution : The appropriate position is that the top of the lens is in the position
a little ahead from the end of the main body.
(from 0 cm up to approximately several centimeters)
Fixing
Top board
shading cover
drawstring
several centimeters
open