Nipros ES-600P - Manual (Page 22)

24
タリー信号の接続
TALLY signal connection
TALLY signal
MONITOR
OUT
TC OUT
Y IN
H S U P
TALLY OUT
RET OUT
MADE IN JAPAN
AUX
Pb IN
Pr IN
FOCUS IRIS
ZOOM
(VIDEO OUT/TC IN)
REMOTE ▲
▲HEADSET
AUDIO IN ▲
VIDEO IN
CAMERA AUDIO OUT EXT LINE (2W I/O) EXT LINE (2W I/O)
HD/SD COMPONENT OUT VIDEO OUT
VIDEO IN AUX
ZOOM
TC OUT FOCUS
IRIS SDI IN OUT 1 OUT 2 OUT 1 OUT 2 SDI RET IN
TC IN RET IN
TALLY EXT LINE (4W I/O)
IN OUT
Y Pb Pr
AC IN
ES-600P
TALLY OUT to
monitor
ES-500P
タリー信号を出力する場合は、ES-500 の TALLY OUT コネクタからモニターへ BNC ケーブルで接続します。
Connect the TALLY OUT connector of the camera adaptor ES-500P to a monitor with a BNC cable. 1
2
スイッチャーからのタリー信号は、TALLY EXT LINE (4W I/O) IN コネクタへ HD D-sub15 ピンケーブルで接続します。
次の ES-600P へタリー信号を出力する場合は、TALLY EXT LINE (4W I/O) OUT コネクタから HD D-sub15 ピンケーブル
で接続します。
Connect the tally output signal from a switcher to the TALLY EXT LINE (4W I/O) IN connector with the
HD D-sub 15-pin cable.
Connect the TALLY EXT LINE (4W I/O) OUT connector to the next base station ES-600P with the HD D-sub
15-pin cable.
TALLY signal
from
switcher,
etc.
to the next
base station
TALLY signal
Multi-core Studio System ES-600P/ES-500P ES-600P 接続方法