Nipros ES-500P System Connection Manual - Manual (Page 3)

ES-600P
Base Station
1
-1. Adjusts the volume level of input.
-2. Adjusts the volume level of output.
-3. Adjusts the volume level of SIDE TONE, return of own input.
INTERCOM EXT LINE (4W I/O) Volume
INTERCOM HEADSET Volume
(front)
Selects the tally channel to light up.
Lights up according to the setting of TALLY SELECT switch
when the tally signal is input to the TALLY IN connector.
Adjusts the volume level of an external 4-wire intercom system
connected to AUX/INCOM 4W connector (XLR 5-pin).
Connects the Intercom headset DL-400.
INTERCOM HEADSET
Adjusts the volume leval of the Intercom headset DL-400
connected to the HEADSET connector.
-1. Adjusts the volume level of the microphone.
-2. Adjusts the volume level of the headphone.
-3. Adjusts the volume level of the SIDE TONE, return of own
voice to the headphone from the microphone.
1 MIC (G)
2 MIC (H)
3 H.PHONE(G)
4 H.PHONE(H)
25
50
75
100
EXT LINE (4W I/O) INTERCOM HEADSET
ES-600
CABLE
CABLE select switch
Set to the appropriate position according to the length
of a 26-pin multi-cable connected to the CAMERA
connector on the rear panel.
POWER switch and indicator
Turns the power on and off.
TALLY SELECT switch
TALLY indicator
(XLR 4-pin)
For using ES-600P/ES-500P.
ES-600P Outsideview / Parts Names and Functions (Front panel)
Operating
Instructions
TM
ES-600P/ES-500P incorporates the REMOTE connector
according to the Panasonic camera remote cotroller. ES-600P/ES-500P : for Panasonic camera
NOTE : ES-600P and ES-500P do not convert the media or format of the input signals to annother.