Krell S-300i - Manual (Page 11)

F ront Panel/ Remote Control Description
See Figures 1 and 2 on page 6
Krell S-300i 7
P o w e r, analog input selections, and volume control accessed via
the front panel of the S - 3 0 0 i are described in the illustration legend
b e l o w. The front panel display shows volume and balance levels,
and Theater Throughput status. Most front panel features can also
be activated via the keys on the remote. Descriptions of special
operational features of the remote control are outlined on pages 9-
1 0 :
1 Power Button or Key
Use this button to switch the S - 3 0 0 i between the stand-by and the
operational modes.
2 Stand-by LED
The red stand-by LED illuminates when the S - 3 0 0 i is plugged into
a standard AC wall receptacle and the rear panel power button is
pressed, indicating that the amplifier is in the stand-by mode and
ready to be switched to the operational mode.
3 Infrared Sensor
The infrared sensor receives commands from the S-300i r e m o t e
control. For proper remote control operation, make sure that noth-
ing is obstructing the infrared sensor.
4 S-1, S-2, S-3, B-1 and iPod Buttons and Keys
Use these buttons to select a balanced analog source component
(B-1) via an XLR connector or a single-ended analog source com-
ponent (S-1, S-2, or S-3) via single-ended RCA connectors or an
IPod input via a special 30-pin connector.
5 Mute Button or Key
Use this button to interrupt the signal of the input you have select-
ed. To unmute, press the mute button again.
6 Menu Button or Key
Use this button or key to access the menu functions of the S-300i.
PO W E R
A N A L O G
S O U R C E
C O M P O N E N T S