Kino Flo Image 87/47 DMX Series - Manual (Page 7)

7
Image Yoke Mount
The Yoke has a ½” hole to accept industry standard
mounting hardware.
The Image 87 Yoke Mount can hang from a grid by a
junior pipe hanger using a Junior Pin Assembly for
Yoke (MTP-I80), sold separately.
The Image 47 Yoke Mount can also hang from a grid by a
junior pipe hanger using a Junior Pin Assembly for Yoke
(MTP-I80) or hang from a baby pipe hanger using a Baby
Receiver Assembly for Yoke (MTP-I40), both sold separately.
Note: Because of weight capacity, the MTP-I40 can only be
used on the Image 47 Yoke Fixture.
MTP-I80 Junior Pin Assembly for Yoke (28mm)
MTP-I40 Baby Receiver Assembly for Yoke (16mm)
The Yoke Mount is also designed with two holes to allow
the yoke bracket to be placed in one of two positions.
The additional option is useful when hanging the units in
a studio with a low ceiling.
Warning: Use only 10-32 x 3/8” screws (supplied) to assemble yoke. Note that
threads on the fixture are self-locking and may seem tight. Replacement screws:
Part No. 2020058
Recommended torque setting:
USA: 18 lb-in
Metric: 2 Nm
1) Align the two hinge bracket tabs with the two square vents closest to the silver lock pins.
2) Press the brackets down into the vent and slide them over to engage the lock pins with
the hole in the bracket.
3) To remove the barndoor, press down on the two lock pins and slide the brackets back.
4) Adjust the hinge tension with a Phillips head screwdriver.
2
1