Faqs – JK Audio RemoteMix 4 User Manual
Page 15
FAQs
11
6) What kind of device can I connect to the Cue Input?
Setting the switch for the dual-purpose 1/4” input to Cue Input will provide
a standard line level input for connection to another audio device, such as
a portable radio. The audio signal will be sent to all three of the headphone
outputs. This way, your announcers can listen for a cue from their radio
station at the end of a station break.
7) The cellular interface cable was left behind at our last event.
Can I get a replacement at our local audio supply store?
This is a custom made cable and is not wired the same as those that may
be available at your local electronics store. Please contact your JK Audio
dealer or our Customer Service department and ask for either a CN045 or a
CN113 replacement cable. The CN045 has a 2.5mm TRS headset plug and
the CN113 has a 3.5mm TRRS headset plug. Most newer phones, especially
those that include a mp3 player, have a 3.5mm TRRS headset jack and
therefore require the CN113 cable.
8) The output from Mic 4 is very low but the other mics are fine.
Check the position of the
switched to accept a line level signal from a mixer or other equipment.
9) How can I tell how much battery life is remaining?
The red
as the battery runs down. This red LED will go completely dark about a half
hour before the unit shuts down. Keep in mind that the VU meter, Bluetooth,
and clipping LEDs will remain bright until the unit stops functioning.
10) Does the AC power supply charge the batteries?
No. You may use rechargeable batteries, but you must remove and recharge
the batteries outside of the RemoteMix 4.
11) I’ve lost my power supply for my RemoteMix 4 unit.
I
have a power supply that fits from a different product. Can I
use this instead?
No! Never use a power supply other than the one that was supplied by your
manufacturer. Power supplies are available in either AC or DC output with
many combinations of voltage and available current. Most consumer power
supplies are not regulated. This could invariably damage your equipment, and
also create a great deal of noise. Our products are designed for and tested
with their respective power supplies for optimum operation. If you have lost
your power supply, please contact your JK Audio dealer or our Customer
Service department and ask for a PS009 power supply for your RemoteMix 4.
FAQs