Chapter, 8‐ chapter 5 specification – IDX CW-5 User Manual
Page 10

‐8‐
CHAPTER 5 SPECIFICATION
5.1 Basic Specification
Wireless LAN Interface
Standard IEEE802.11a (ARIB STD-T71)
Transmission method
Orthogonal Frequency Division Multiple
Modulation (OFDM)
Frequency
5,150~5,250MHz (4ch) Auto-select
5,150~5,350MHz (8ch) Auto-select U.S. Spec
Data transfer speed
6/12/24Mbps Auto Switch
Encryption AES
Encryption
Transmission power (max)
*1
Japan: 180mW/18MHz
U.S.: 50mW/20MHz
Europe: 200mW/20MHz
Reception sensitivity
-74dBmW typ.
*1: The max power setting is governed by the 802.11a regulations of each
country.
5.2 Input・Output Specification
CW-5TX
(
transmission side)
Specification
Video / Audio
Video signal
NTSC/PAL/SECAM auto selection
Composite Input
1.0Vpp/75Ω
Audio Input
0dB 10KΩ Balance
Compression method
MPEG-2
MPEG bit rate
4/8/14Mbps Auto switch
Infrared Signal
*
for pairing operation
Signal carrier frequency
38KHz
Display・Operation
Power switch
Turns the CW-5 Power ON/OFF
Note: If a battery is attached the battery power is
throughput to the output side even when the CW-5 is off
Pairing Switch
As shipped the CW-5 TX & RX are preset paired
For manual pairing push down the pairing set switch
The most recent paired information is always retained