HF scientific MicroTUV Online UV %Transmission Analyzer - Manual (Page 8)

TUV (1/03)
REV. 0.2
2.0 INSTALLATION
2.1 PACKING LIST
CONTENTS QUANTITY
Mounting Bracket - installed 1
RS-485 Interface - installed 1
O & M Manual 1
Power Cord - installed 1
A complete listing of spare parts appears on page 9 of this manual.
2.2 UNPACKING AND INSPECTION
Use extreme care when unpacking your TUV Analyzer and check that all of the contents
are included. Check for any damage that may have occurred during shipping. If there is any
shipping damage; notify the shipping company immediately and arrange for a prompt inspec
tion. If there are any omissions, report this immediately to the Service Dept. at HF scientific, inc.
for assistance.
2.3 MOUNTING
NOTE: Be careful during installation not to violate the integrity of the Analyzer enclosure. The
system requires approximately one hour to reach its final operating temperature. Further
adjustment of the Analyzer’s LCD brightness may be required after this period (see Utility Menu,
Screen Brightness/History).
If it is possible, avoid mounting the Analyzer where it will be difficult to read the LCD screen
because of direct sunlight. After mounting, the angle of the Analyzer may be adjusted for
best visibility.
2.4 ANALYZER CONNECTIONS
All connections are reached by removing the access cover. Obey the following warnings and precautions prior
to removal.
WARNING: Before removing access cover disconnect all power to the TUV Analyzer.
Step 1) Unplug the instrument or turn off the power at the circuit breaker.
Step 2) Remove power to alarm contacts if greater than 30 VAC is connected for external operations.
Page 2