HCO SR1-IR - Manual (Page 5)

4
2. Insert a SD card (32GB or smaller). Open the camera and insert the SD
card into the card slot. Refer to the card symbol on the case for proper
orientation. The camera supports up to 32 GB SD card. Please note that
the SD-card should not be locked.
3. Slide the power switch to the SETUP position. The camera will enter the
live preview mode.
4. Press button to enter into the menu, then press
◄ or ► buttons
to move between the tabs (submenu) which contains different group of
items. Press the ▲ or ▼ buttons to activate the submenu and edit
different items. P
ress ◄► to change the value. Press the OK button to
save.
5. Press button to exit from the submenu. Press the MENU again
to exit from setup menu and enter the live preview mode.
6. Press the OK button to capture image or record video manually.
7. Press the playback button to playback. Use the
◄ or ► buttons to go
through the images. Press
▲ or ▼ button to choose magnification times.
Press OK and ▲▼
◄► to move the magnified area.
8. Press Playback button to exit.
9. While reviewing the image, press button to delete the current
image, or press button to delete the current one or all the
images.
10. Press Playback button to exit the playback mode.
11. Place the camera at the target area and turn on the camera (slide the
power switch to ON). The camera will take pictures or videos as
programmed. The height from the ground for placing the camera should
vary with the object size appropriately. In general, 3-6 feet is preferred.
12. Push the power switch to the OFF position to power off the camera.
Please note that even in the OFF mode, the camera still consumes a