Heatseal sprint h925 - load film from empty, Heatseal sprint h925 - alert indicators, Step 1 – GBC H925 User Manual
Page 5: Step 2, Step 3, Step 4, Top cover alert, Low film alert
8
9
STEP 1
First, complete steps 2, 3 and 4
from “Load Film” page 7. Close 4
EZload levers.
STEP 2
Press Feed switch (forward) and
insert the threading card (supplied
with EZload film) as shown. Insert
card with slight force through film
rollers.
STEP 3
Insert idler bar assembly. Continue
pressing feed switch and wait for
clear, wrinkle-free lamination.
STEP 4
Close top cover, select film
thickness.
Start
Stop
3 mil / 75 mic
5 mil / 125 mic
(Film Select)
Use instructions below to load new film if completely empty.
Caution, hot surfaces.
HeatSeal Sprint H925 - Load Film from Empty
TM
®
TOP COVER ALERT
Top cover is open. Close the cover
and resume lamination.
LOW FILM ALERT
Open top cover and load new
film rolls. Refer to “Load Film”,
pg. 7 and 8.
Start
Stop
3 mil / 75 mic
5 mil / 125 mic
Start
Stop
3 mil / 75 mic
5 mil / 125 mic
(Alert LED)
(Low Film LED)
Do not take machine apart - No user servicable parts.
HeatSeal Sprint H925 - Alert Indicators
TM
®