GBC 61 Plackmatic Bookmaker - Manual (Page 20)

20
OPERATOR MANUAL BM 61 T10165
4.1.6 Block stapling - OFF-line option 2
Lower the rear jogger by pressing the rear jogger unit forward (green marked).
Remove the upper pressure roller.
Flip over the side jogger upper guides (both side joggers).
Open the top cover.
Set the side jogger to the correct paper size according to the scale.
Insert the two red pins in the holes in the side joggers. (The pins are stored inside the
machine over the fold rolls). These will stop the set in the correct position (in this mode
the set will not be transported through the machine).
Insert set into the stapling area.
Move the rear side jogger up against the paper to verify that the side jogger aligns the
sheets.
NOTE: When checking the alignment, do not squeeze the release handle, only push
on top of the side jogger at the green label, to simulate the jogging action that the
BM 61 does during run.
Remove the set.
Position the stapler heads over the correct anvils.
Set the stapling switch to
ON position.
Set the folding switch to OFF position.
Select manual start.
Close the top cover.
Set the power switch to
ON position.
To operate insert one set and press the manual start button. When stapled, remove set
and insert the next one.
1.
2.
.
4.
5.
6.
7.
8.
9.
10.
11.
12.
1.
14.
15.
16.