GBC 61 Plackmatic Bookmaker - Manual (Page 17)

T10165 OPERATOR MANUAL BM 61
17
4. Operator instructions
4.1 Settings
4.1.1 Stapling and folding
Open the top cover.
Set the two side joggers to the correct paper size according to the scale.
Insert a set to the stapling area.
Move the rear side jogger up against the paper to verify that the side jogger aligns the
sheets.
NOTE: When checking the alignment, do not squeeze the release handle, only push
on top of the side jogger at the green label, to simulate the jogging action that the
BM 61 does during run.
Turn the paper stop crank until the trail edge of the set is in line with the scale for paper
length.
Move the rear jogger up against the trail edge of the set.
Remove the set.
Position the upper pressure roller according to the scale.
Position the stapler heads over the anvils to be used.
Attach the Booklet Maker to the Collator and make sure that the green mark on the
Docking Bracket aligns with the green mark on the Collator.
Set the stapling switch to
ON position.
Set the folding switch to ON position.
Close the top cover.
Set the power switch to
ON position.
1.
2.
.
4.
5.
6.
7.
8.
9.
10.
11.
12.
1.
14.
4.1.2 Folding only
1. Same procedure as above with the exception that on point 11 the switch is set to OFF
position and point 9 is not performed.