E-flite Jenny JN-4 Slow Flyer 250 ARF - Manual (Page 8)

8 E-flite Jenny JN-4 Slow Flyer ARF Assembly Manual
Motor Installation
Required Parts
• Fuselage • Receiver
• Park 250 Brushless motor • Electronic speed control (ESC)
• 1 1 /
2
-inch (38mm) motor tube
Required Tools and Adhesives
• Phillips screwdriver • RTV silicone
• Double-sided tape • Foam-safe CA
• Sandpaper
 1. Locate the 1 1 /
2
-inch (38mm) motor tube. Follow the
instructions to glue (using RTV silicone) the motor to the
motor tube. Be careful not to get glue inside the motor
bearing.
 2. Lightly sand the motor tube once the adhesive used to
glue the motor to the motor tube has fully cured.
 3. Remove the two screws holding the cowl to the
fuselage and slide the cowl away from the fuselage.