E-flite Fury 15 DF BNF Basic - Manual (Page 9)

EN
Control Direction Tests
Assemble the aircraft and bind your transmitter to the receiver before perform-
ing these tests. After binding a transmitter to the aircraft receiver, set the trims
and sub-trims to 0, then adjust the clevises to center the control surfaces. Move
the controls on the transmitter to make sure the aircraft control surfaces move
in the proper direction.
AS3X Control Direction Test
This test ensures that the AS3X ® control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Advance the throttle to 25% to activate the AS3X system.
2. Fully lower the throttle.
3. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fl y the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X is active until the battery is disconnected.
Aircraft
movement
AS3X Reaction
Elev
ator
Aileron
Rudder
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing at the root.
This CG location has been determined with the recommended Li-Po battery
(EFLB32004S30) installed in the middle of the battery compartment.
155mm
6.1 inches back from the
leading edge of the wing at
the root.
9