E-flite Fury 15 DF BNF Basic - Manual (Page 12)

EN
Problem Possible Cause Solution
Oscillation
Damaged rotor or spinner Replace rotoror spinner
Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver Align and secure receiver in fuselage
Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Worn parts Replace worn parts (especially rotor, spinner or servo)
Irregular servo movement Replace servo
Inconsistent fl ight
performance
Trim is not at neutral If you adjust trim more than 8 clicks, adjust the clevis to remove trim
Sub-Trim is not at neutral No Sub-Trim is allowed. Adjust the servo linkage
Aircraft was not kept immobile for
5 seconds Power off and on the ESC while keeping the aircraft still for 5 seconds with throttle stick in lowest
position
Troubleshooting Guide AS3X
Tip: For belly landing, remove the nose gear from the fuselage.
1. Remove the 6 screws (A) and the nose cover (B) from the fuselage.
2. Loosen the set screw (C) in the steering arm (D) using a hex wrench, then
remove the arm from the nose strut (E).
3. Remove the nose strut from the cover.
4. Disconnect the nose gear linkage (F) from the innermost hole in the
steering servo arm (G).
5. Disconnect the steering servo from the servo extension in the fuselage.
CAUTION: DO NOT crush or otherwise damage wiring when attaching
the cover to the fuselage.
6. Install the nose cover on the fuselage using the 6 screws.
B
A
C
E
G
Nose Gear Removal
12