E-flite Viking Model 12 280 BNF Basic - Manual (Page 9)

9
EN
Control Direction Test
Bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make
sure the aircraft control surfaces move correctly and in the proper direction.
Always keep throttle at the low position during testing.
Make sure the tail linkages move freely and that paint or decals are not adhered to them.
AS3X Control Direction Test
Assemble the aircraft and bind your transmitter to the receiver before performing this Test. Activate the
AS3X
® system by advancing the throttle to 25%, then fully lowering the throttle.
Move the aircraft as shown to ensure the AS3X system moves the control surfaces in their proper
direction. If the control surfaces do not respond as shown, do not fl y the aircraft. Refer to the receiver
manual for more information.
Once the AS3X system is active, the
control surfaces may move rapidly
on the aircraft. This is normal. AS3X
will remain active until the battery is
disconnected.
Aircraft
movement
AS3X Reaction
Elev
ator
Aileron
Rudder