E-flite Viking Model 12 280 BNF Basic - Manual (Page 5)

5
EN
Wing Installation
1. Put the wing servo connectors into the hole in
the bottom of the fuselage.
Tip: If needed, use hemostats or pliers to
pull the servo connectors into the fuselage.
CAUTION: DO NOT crush or otherwise
damage the wiring when attaching the wing
to the fuselage.
2. Apply foam-compatible medium CA to the
center section of the lower wing, and attach it
to the under side of the fuselage.
3. Place the upper wing cabane rods fully in the
fuselage mounts. Do not glue at this moment.
Assembly
Prefl ight Checklist

1. Charge fl ight battery.
2. Install fl ight battery in aircraft (once it has
been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.

6. Adjust center of gravity.
7. Perform a radio system Range Check.
8. Find a safe and open area.
9. Plan fl ight for fl ying fi eld conditions.
Required Adhesives:
foam-compatible
Medium CA