E-flite Odyssey EP Electric Glider - Manual (Page 8)

Parts Needed
• Horizontal stabilizer with elevator attached
• Vertical stabilizer with rudder attached
• Nylon control horns (2)
• Nylon backplates (2)
• 2 mm screws (4)
• 2 mm nuts (4)
Tools and Adhesives Needed
• Medium Phillips screwdriver
• Felt-tipped Pen
• Drill Bit: 1/16"
• Drill
Step 1. You will attach the rudder and elevator control horns
next. Locate the two nylon control horns, the two backplates and
the four 2 mm control horn screws and nuts
Step 2. Install the elevator control horn first. It will be located
on the bottom of the elevator, as shown in the photo below.
Please note that the trim is located on top of the elevator.
Step 3.Mark the post where the horn will be placed using
a felt-tipped marker and drill the marked locations using a
1/16" drill bit.
Step 4. Mount the rudder control horn to the vertical fin/rudder
using the two screws and nuts provided. Mount the control horn
on the left side of the rudder using the same method as above.
8
Section 2: Installing Rudder and Elevator
Control horns