E-flite Carbon-Z Scimitar BNF - Manual (Page 10)

EN
Installing Wings and Vertical Fins
1. Install the long carbon fi ber wing tube (A) into the rear hole on
the side of the fuselage.
2. Install the short carbon fi ber wing tube (B) into the front hole
on the side of the fuselage.
3. Install the left and right vertical fi n bodies (C) on the wing
tubes on each side of the fuselage using screws (D). (Rudder
control arms face the inner side of the vertical fi n.)
4. Connect the rudder servo connectors of the vertical fi ns to
connectors (E) (marked RUDD) on each side of the fuselage.
5. Install the left and right wings (F) on the wing tubes on each
side of fuselage.
6. Connect the aileron servo connectors to connectors (G)
(marked AILE) on each side of the fuselage.
NOTICE: Always put excess connector wire into the pocket of the
wing to prevent pinching of wires or other damage.
7. Turn over the model so the bottom of the fuselage faces up.
8. Make sure the left and right wings are fully in contact with
the fuselage, then install the four screws (H) in the wing and
fuselage.
Disassemble the model in reverse order.
2.5 X 14mm (2)
D
A B
C
3 X 12mm (4)
H
AILE
RUD
AILE
RUD
AILE
RUD
F
E
G
10