beautypg.com

Wing preparation, Wing.preparation – E-flite Ultra Stick 25e ARF User Manual

Page 17

background image

2. Attach the stabilizer using two 3mm washers and

two 3mm locknuts. Do not tighten the locknuts all
the way until after the wing is installed and you
check the alignment.

Note:.The.tail.section.is.removable.for.easy.

transporting.if.needed.

Wing Preparation

Required Parts

• Wing

• 6-channel receiver

• Servo w/hardware (2)

• Servo extension, 6" (2)

• Clevis (2)

• Pushrod connector (2)
• 5

5

/

8

" (143mm) pushrod wire (2)

Required Tools and Adhesives

• Drill

• Drill bit: 1/16" (1.5mm), 5/64" (2mm)

• Screwdriver, #0 Phillips

• Pliers

Note:.For.the.optional.Quad.Flap.modification,.

please.refer.to.information.on.Page.20.

Note:.Check.to.make.sure.the.aileron.hinges.

are.glued.securely.by.gently.pulling.on.the.two.

surfaces..If.they.are.not.glued.securely,.apply.

thin.CA.to.both.sides.of.the.hinge.to.secure.

them..Do.not.use.accelerator..The.CA.must.be.

allowed.to.soak.into.the.hinge.to.provide.the.

best.bond.between.the.hinge.and.surrounding.

wood.

17