Tail installation, Tail.installation – E-flite Ultra Stick 25e ARF User Manual

Page 16



1. Slide the rudder into position on the fuselage.

The threaded rods extend through the bottom
of the fuselage.

Tail Installation

Required Parts

• Fuselage

• Rudder/Fin

• Stabilizer/Elevator

• 3mm locknut (2)

• 3mm washer (2)

Required Tools and Adhesives

• Nut driver: 1/4"

Note:.Before.installing.the.tail,.check.to.

make.sure.the.hinges.are.glued.securely.by.

gently.pulling.on.the.two.surfaces..If.they.are.

not.glued.securely,.apply.thin.CA.to.both.

sides.of.the.hinge.to.secure.them..Do.not.

use.accelerator..The.CA.must.be.allowed.to.

soak.into.the.hinge.to.provide.the.best.bond.

between.the.hinge.and.surrounding.wood.