DJI Lightbridge User Manual - Manual (Page 44)

©2014 DJI. All Rights Reserved. 44
8 FAQ
1. Q: Unable to download DJI LIGHTBRIDGE App from Google Play.
A: Follow one of the methods below to download or update the App.
 Scan the QR code on the quick start guide to download.
 Input the URL of “http://m.dji.net/lightbridge” in the address bar of browser to download.
 If you have installed the App before, go to "Settings" -> "About" -> "Check new version" to update
it.
2. Q: Can I use 5.8GHz transmitter to control the gimbal?
A: Yes. Use the lever kit to control the gimbal on Phantom.
3. Q: Can SBUS decoder decode the SBUS signal from the DJI LIGHTBRIDGE?
A: Yes.
4. Q: Is it possible to use single FUTABA transmitter to simultaneously control aircraft and gimbal?
A: Yes. You will need to assign the channels from aircraft and gimbal through DJI LIGHTBRIDGE App.
5. Q: Is it possible to two different brands of transmitter to simultaneously control aircraft and gimbal?
A: Yes. As long as both of the transmitter have PPM output.
6. Q: How to solve the issue of aircraft losing control within couple hundred meters, accompany with blur
screen?
A: Follow the instruction below to resolve this issue:
a) Check if the antenna installation location unobstructed. Try to keep both ends of the antennas
as far as possible. Keep away from metal.
b) Ensure antennas face downward and make sure antennas is intact, otherwise, it may lead to
transmission lost.
c) Check if the antennas is firmly attached to the air system.
d) Run signal diagnostics in the DJI LIGHTBRIDGE App to determine the cause. Remove one of
the antennas, place ground system two meters away from air system and launch DJI
LIGHTBRIDGE App. Enter “Signal Diagnostic” page to check the signal strength. Green bars
indicates signal strength is normal, and readings should falls in the range of -20 to 40. If not,
adjust ground system antennas orientation.
e) Repeat step a,b,c. If problem persists, replace antenna.
f) Contact DJI tech support for assistance.