1 using lightbridge assistant, 2 remote control channel settings – DJI Lightbridge User Manual User Manual

Page 36

5.2.1 Using LIGHTBRIDGE Assistant

Start up the PC and ground system then connect it to the PC with a Micro-USB cable. DO NOT

disconnect until configuration is finished.

Run LIGHTBRIDGE Assistant and wait for the ground system to connect. Watch the indicators on the

bottom of the screen. When connected successfully, the connection indicator is green and solid on

and communication indicator blinks blue.

Go to “Channels” page to check both aircraft channels and gimbal channels.

5.2.2 Remote Control Channel Settings

If you change the remote control, it is necessary to set the channels again through LIGHTBRIDGE Assistant, so

that the remote link function can be use normally. Steps to set up the remote channel:

Connect the Remote Control to PC, enter the main page.

Select “Default Map”, as the page shown below: