DJI 2.4G Bluetooth Datalink & iPad Ground Station - Manual

©2013-2014 DJI. All Rights Reserved. - 1 -
2.4G Bluetooth Datalink & iPad
Ground Station User Guide
V1.12
Thank you for purchasing DJI products. Please strictly follow this user guide to mount and connect the 2.4G
Bluetooth Datalink, install the Assistant Software on your computer, as well as the App on your mobile device.
Note ：The map of Mainland China download from Mainland China IP addresses has differences with the actual
geographic environments. If users download the map of Mainland China from foreign IP addresses, which will be
more accurate.
2.4G Bluetooth Datalink
The 2.4G Bluetooth Datalink consists of the Air end and the Ground end, which provides reliable and stable remote
wireless transmissions for Ground Station based applications. The signal flow is as shown below.
The Air
end
The
Ground end
Flight control
system
PC Ground
Station
iPad Ground
Station
CAN-Bus
USB
Bluetooth Bluetooth
Signals from
Ground Station
Signals from Flight
control system
BTU module
CAN-Bus
Flight control systems that support the 2.4G Bluetooth Datalink
ACE ONE(Firmware V4.02 or above), WKM(Firmware V5.24 or above),
NAZA-M, NAZA-M V2(Firmware V4.00 or above), A2(Firmware V2.0 or above)
Important: To make your Phantom 2 compatible with the 2.4G Bluetooth Datalink, please update the firmware of
Phantom 2 and BTU module to the latest version.
1.1 In the box
BTU
Module
USB
cable
CAN-Bus
cable
DC power
cable
The Ground end of
2.4G Bluetooth
Datalink The Air end of
2.4G Bluetooth
Datalink
Important ：the firmware of BTU should be upgraded to version 1.0.1.2 or above to use with the 2.4G Bluetooth
Datalink.
1.2 User supplied
To use the 2.4G Bluetooth Datalink and Ground Station, please prepare the Flight control system, the aircraft,
batteries, PC or iPad etc.