DJI E300 - Manual (Page 2)

©2013 DJI Innovations. All Rights Reserved. 2
In the Box
Motor(Clock-wise rotation) Motor(Counter clock-wise rotation) Propeller Pair
ESC Accessories Pack
Power Hub,
Screws (
M2.5*
Φ5*1.3*1 ) , Screws (
M3*
Φ4.9*6.8 ), Screws (
M3*
Φ5.5*4.5 ),
Wrench for propeller fix, 2.0mm hexagonal wrench, Double side tape, etc.
Tools Needed
Tool Function
Electric Soldering Iron & Soldering Tin Connects the ESCs’ power cables to the power hub.
Soldering the ESC
1. Please solder the ESC to the power pads on the power hub as the figure shows. Make sure the welding
spot is firmly attached on the power pads and no short circuit. Do not damage the protector of the red
cable to avoid short circuit.
2. Connect the signal cable to your controller.
3. Connect the motor to the ESC. Make sure the rotation direction of each motor is the same as the way of
defined rotation direction. If not, switch any of two cables that connecting the motor and the ESC to
change its rotation direction.
E300
To the controller
The outer power pads are for the GND cables, and the
inner power pads are for the power cables. Make sure to
solder them correctly. Try to make the cables firmly
soldered on the power hub with suited length (Should not
leave any outside the power hub), and outward-facing.
Make sure there is no short or open circuit.
It is recommended to solder a power connector on the power hub.