Step3: flying test – DJI BTU User Manual

Page 2

5. Make sure NM Assistant and autopilot system connect successfully.

6. Set flying parameters in NM Assistant.

Step3: Flying test

Prepare the aircraft and make sure all connections are ok. Start Motors to takeoff the

aircraft.

View flying parameters.

Set gain value.

Set gimbal parameters.

Only gain value and gimbal parameter are available to configure during

flying; other parameters can be set only after landing.

FAQ

Problems

Reasons

Solutions

Status Indicator of

BTU is not solid

Green on.

Firmware of MC is out of date.

Please update firmware.

BTU and autopilot system

connection failure.

Please check the connection.

BTU damage.

Please contact your dealer.