Cyclopital3D Fuji W1 Close-up Macro Adapter - Manual (Page 2)

Instructions for use:
1. Slide lens cover open.
2. Insert camera into adapter.
3. Attach to camera by inserting thumb screw into the tripod mount.
4. Turning your camera on (and off). If the camera is off, press and
hold the “play” button on the top right of the control panel on the
back of the camera. The camera will power up in playback
mode, switch to camera mode by half pressing the shutter but-
ton. To turn the camera off, press the play button once which will
return it to playback mode, then press and hold the play button
until camera turns off.
5. Adjust the zoom. When the camera is first turned on, the lens
will be at minimum zoom. To use the adapter you will need to
zoom in until there are no obstructions seen on the display- you
will see the black sides of the adapter until it is appropriately
zoomed in.
When using a flash:
• The flash hot shoe will accommodate almost any kind of flash unit
that has a hot shoe adapter.
• The camera must be set to “forced flash”.
• Red-eye removal mode must be OFF.
• Set the camera to manual mode, set ISO, aperture and shutter
speed to appropriate values for the lighting making sure that the
flash is set with identical values.
• It is recommended to use the flash in auto mode, with the same
values as your camera.
• Note: because an additional battery is not needed to power the
flash control unit, it does not work with some older, high-voltage
flash models. A list of known compatible flash models is being
updated continuously and is posted at www.cyclopital3d.com.
Expand the PotenƟal of your Fuji W3!
Auxiliary Lens Adapter
Use with 37mm wide angle and fish-eye lenses
Base Extender
Increases stereo base to 225mm!
Perfect for wildlife, landscapes and band or wedding photos.
All rights reserved, Cyclopital3D, Inc. 2010