Cyclopital3D Fuji W1 Auxiliary Lens Adapter - Manual (Page 2)

3
Instructions for use:
1. Slide lens cover open.
2. Insert camera into adapter.
3. Attach to camera by inserting thumb screw into the tripod mount.
4. Turning your camera on (and off). If the camera is off, press and
hold the “play” button in the middle of the control panel. The
camera will power up in playback mode, switch to camera mode
by half pressing the shutter button. To turn the camera off, press
the play button once which will return it to playback mode, then
press and hold the play button until camera turns off.
The adapter can also be used with
lens hoods for reducing glare and
improving contrast:
When using a flash:
• The flash hot shoe will accommodate almost any kind of flash unit
that has a hot shoe adapter.
• The camera must be set to “forced flash”.
• Red-eye removal mode must be OFF.
• Set the camera to manual mode, set ISO, aperture and shutter
speed to appropriate values for the lighting making sure that the
flash is set with identical values.
• It is recommended to use the flash in auto mode, with the same
values as your camera.
• Note: because an additional battery is not needed to power the
flash control unit, it does not work with some older, high voltage
flash models. A list of known compatible flash models is being
updated continuously and is posted at www.cyclopital3d.com.
4
Expand the PotenƟal of your Fuji W3!
Close-up/ Macro Adapter
Decreases stereo base to 25mm!
Base Extender
Increases stereo base to 225mm!
Perfect for wildlife, landscapes and band or wedding photos.
All rights reserved, Cyclopital3D, Inc. 2010