CommScope ATC200-LITE-USB - Manual (Page 4)

3. Controller program startup
2. Device search. Click on Find Devices.
A device search is required each time the controller program is
closed and reopened.
3a. Device conf guration.
Select appropriate device to be conf gured and click on Edit Selected.
1. Program startup.
• The Andrew website should be checked every 30 days for updated
software, f rmware, and documentation.
• Double-click on the ATC Lite program icon on the computer’s desktop.
• The latest Andrew antenna def nition f le is automatically loaded by
the controller during program startup. If an antenna is not listed
when conf guring (see Step 3B), select Tools→Antenna Files... from
the program’s main menu. Select the desired f le from the drop down
menu provided. (The antenna f le revisions are in sequential order.)
Click Load File, Close.
• If you would like to verify the port assigned for the connection or
change the com port, click on Communication from the main menu.
• Note the program will only be able to perform self testing and RET
operations when a RET device or system is connected into the
controller’s AISG port.
Actuators that have been factory installed on an antenna are pre-conf gured
to include the antenna model number, antenna type, and antenna serial num-
ber. The remaining f elds (Installation Date, Mechanical Tilt, Bearing, Height,
Sector, Location, Freq. Band, Technology, Station ID, and Installer ID) will
need to be conf gured, as seen on the following screen.