Clearaudio STATEMENT - Manual (Page 17)

Statement
User Manual
Page 17  Clearaudio electronic GmbH 2013
5. Special directions
The Clearaudio Statement does not require any extensive maintenance.
If the Statement turntable is not in use for a long time please disconnect the motor from the
mains supply.
Every two years you can lubricate (only if you notice speed variation) the bearing of the turntable
platter with the supplied oil. In this case it is only necessary to put 4 or 5 drops of the oil onto the
bearing shaft.
Don’t use abrasive cleaning fluid for the Statement turntable. A few drops of window cleaner in a
glass of water is sufficient.
Carefully dry all cleaned parts with a cotton lint-free cloth.
The acrylic parts must only be cleaned with special acrylic cleaning fluids and under no
circumstances spirit or fluids based on alcohol. (To avoid the danger of surface damage!)
You will find suitable cleaning fluids either in specialised shops or in the Clearaudio online shop:
www.analogshop.de .
Please take special care to avoid any damage to the power cord.
Any damage should only be repaired only by authorized personal. A damaged power cord must be
exchanged immediately!
To achieve the full Clearaudio warranty, you are required to fill out and return the corresponding
part of the warranty registration certificate /card to Clearaudio within two weeks after purchase.
Only if the product is returned in it’s original packing can Clearaudio provide service under
warranty.
Transportation advice:
Should it be necessary to transport the Statement turntable, always please be sure to remove the
turntable platter. Otherwise serious damage can occur!
It is also important that the bearing hole is covered to avoid any dust entering the bearing.
Always take of the pulley off of the motor unit to prevent the motor shaft from any damage.