Clay Paky GLOW UP & FLIGHT CASE (F21230) PRELIMINARY - Manual (Page 9)

9 GLOW UP
Shortcut keys menu:
By pressing the ENTER
A key and UP B , the DMX address setting function can be quickly accessed.
By pressing the ENTER A key and DOWN C , it is possible to assign the desired command to the GlowUp Radio module:
1) Use the UP B and DOWN C keys to select one of the following settings:
Unlink Transmitter – Disconnected from the transmitter
Link Receivers – Connected to all free receivers
Unlink Receiver – Disconnected from all receivers
2) Press ENTER A to confirm the selection (the display blinks for several seconds) or SELECT S to keep the current settings and return to the
previous Menu.
By pressing any button when Glow Up is in idle status, the BUTTON FUNCTION menu is accessed.
Press SELECT S SET to access the menus (vedi pag. 10) :
Program
Setup
Manual Control
Information
Advanced
(L'accesso al Menu ADVANCED è consigliato a personale tecnico qualificato)
Press ENTER A MOD to select the Glow UP operating mode
Use the UP B e DOWN C keys to select the mode from those available:
Stand Alone / DMX – Press ENTER A to confirm (runs “Unlink Transmitter”, receives the DMX at the pre-set address; by using the PLAY  key, a scene
may be chosen to be run locally and the DMX being inactive)
Master/Slave (The "Transmitter" transmits to the "Receivers" the default programme in PLAY) - Press ENTER A and select the mode from those available:
• Receiver enables established wired or wireless reception and reads channels, starting from channel DMX 1, without changing the pre-set DMX address.
• Transmitter enables established wired or wireless transmission, transmits starting from channel DMX 1, without changing the pre-set DMX address.
Master/Slave DMX Rec (The "Transmitter" transmits the DMX recording to the "Receivers") - Press ENTER E and select the mode from those available:
• Receiver enables established wired or wireless reception and reads channels, starting from the pre-set DMX address.
• Transmitter enables established wired or wireless transmission, transmits starting from the pre-set DMX address.
NOTE: in a GlowUp series which is part of a battery, it is imperative to first select all the receivers and finally select the Transmitter.
 II
UP B PLAY/PAUSE key: activates or pauses a particular mode.
By pressing the UP B PLAY  button, the sub-menu can be accessed:
Fixed Colours: it is possible to associate a bit value to each GlowUp channel or you can select a color from the stored ones by accessing the Preset Colors
menu (see table on page 9).
È possibile miscelare Strobo e Dimmer con qualsiasi canale colore impostato
Sequence: it is possible to associate Speed and Fade of the pre-set Sequences (Preset 1,2,3)

DOWN C STOP

key: deactivates the active programme.
Symbol SET  or II

MOD
Function Setting Play/Pause Stop Mode
BAT 40% ??
SET MOD
Stand Alone / DMX
Master / Slave
Master / Slave DMX Rec
Mode
Fixed Colours
Sequernces
Play 