Clay Paky GLOW UP & FLIGHT CASE (F21230) PRELIMINARY - Manual (Page 3)

3 GLOW UP
• Installation
Ensure that the Flight Case, when used for charging Glow UP, is positioned at a distance of 15
cm from any surface or wall, to allow proper ventilation.
• Maximum ambient temperature
Do not operate the device if ambient temperature (Ta) exceeds 40°C.
• IP20 protection rating
The fitting is protected against penetration by solid bodies of over 12mm (0.47”) in diameter (first
digit 2), but not against dripping water, rain, splashes or jets of water (second digit 0).
• Protection against electrical shock
Connection must be made to a power supply system fitted with efficient earthing (Class I appliance
according to standard EN 60598-1).
It is, moreover, recommended to protect the supply lines of the projectors from indirect contact
and/or shorting to earth by using appropriately sized residual current devices.
• Connection to the power mains
A qualified electrician must perform connection to the power mains.
Check that the mains frequency and voltage correspond to the frequency and voltage for which the
projector was designed and indicated on the electrical data label.
This label also gives the input power. Refer to the latter to evaluate the maximum number of
devices to be connected to the mains to avoid overloads.
• Maintenance
Before starting any maintenance work or cleaning, cut off power from the supply mains.
SAFETY INFORMATION FLIGHT CASE
The products referred to in this manual conform to the European Community Directives to which
they are subject:
• Low Voltage Directive 2006/95/EC
• Electromagnetic Compatibility Directive 2004/108/EC
IP20