Calculated Industries 6130 v2.0 - Manual (Page 20)

4) Press [Scale] . The appropriate an-
nunciator will begin flashing “ FT
-
IN “ for Imperial Mode, “
MM
” for
Metric Mode.
5) If you want to change the units of
measurement, press [M+] . You can
repeatedly press this key until you
reach the desired unit of measure-
ment. Then press the
[Scale] key to
begin setting the distance.
6) Press [M+] to increment the dis-
tance. When you have reached the
correct number, press
[Scale] to ad-
vance to the next digit. You can
press the
[Mode] key to move back
one digit.
7) Once the desired value has been
set, press [Set] to store value and ex-
it the programming mode.
Note: Pressing [Reset] will exit the pro-
gramming mode without saving any
value as the Custom Scale.
20 – Scale Master ® II v2.0