Calculated Industries 8528 - Manual (Page 4)

ProjectCalc ® Plus MX User’s Guide — 2
Ç 8 — Percent (%)
Memory
Ç = (M+) — Adds the displayed value to the semi-
permanent memory register (e.g., 1 5 0 Ç =).
Semi-permanent means the value is cleared when the
calculator is turned off.
r =
(M-R/C) — Recalls memory value (e.g., if 150
has been stored in Memory, pressing r = will display
150). Note: This function displays, but does not clear, the
memory register.
r r
(M-R/C) — Displays and clears/deletes any
value stored in the memory register.
Ç o
(Off) — Turns calculator off and clears the
memory register.
s = — Memory Store (replaces stored memory
value with the displayed value).
Measurement Unit Keys
m
Enters or converts to metres.
M
— Millimetres
Enters or converts to millimetres.
Ç 7 (cm)
— Centimetres
Enters or converts to centimetres. For example, to enter
50 centimetres, input
5 0 Ç 7.
f
Enters or converts to feet as whole or decimal numbers.
Also used with the
i and / keys for entering Feet-
Inch-Fraction values (e.g., 6 f 9 i 1 / 2).
Repeated presses during conversions swap between Feet-
Inch-Fractions and Decimal Feet.
i
Enters or converts to inches. Entry can be whole or decimal
number. Also used with the
/ key for entering fractional inch
values (e.g., 9 i 1 / 2). Repeated presses during
conversions swap between Fractional and Decimal Inches.
PRG8528E-G 10/23/09 Page 2