Calculated Industries 4095-C Pocket Reference Guide - Manual (Page 14)

P
ocket
R
efeRence
G
uide
— 25
1. Enter Offset:
1
6   OFST 16 INCH
2. Enter Run:
2
7   RUN 27 INCH
3. Find the pipe length:

TRAV 31-3/8 INCH
4. Find the bend angle:

/_Ø 30.65°
Simple Offset – Cut Length
Find the cut length (end-to-end) for a pipe
offset with a 10” Offset and a 12” Run.
The bend angle is unknown. This example
assumes 6” Steel, factory made long radius
butt weld elbows are used. The following
example shows an optional override of the
Welder’s Gap when working with Stainless
Steel.
Note: All Take-Out calculations are based
on Carbon Steel O.D. See the Cut Length
– Known Take-Out Value example to solve
Cut Lengths for known Take-Out values.
KEYSTROKE DISPLAY

 ALL CLEArEd
(cont'd)
(cont'd) KEYSTROKE DISPLAY
KEYSTROKE DISPLAY

 (Default) BW-L EL. tYPE

BW-S EL. tYPE

FC-L EL. tYPE

FC-S EL. tYPE

(Default) BW-L EL. tYPE
Simple Offset – Known Bend Angle
Find the center-to-center travel for a pipe
offset with a 24” Offset.
KEYSTROKE DISPLAY

 0.
1. Enter Offset:
2
4   OFST 24 INCH
2. Enter bend angle:
4
5  /_Ø 45.00°
3. Find the pipe length:

TRAV 33-15/16 INCH
Simple Offset – Unknown Bend Angle
Find the center-to-center travel and unknown
bend angle for a pipe offset with a 16” Offset
and 27” Run.
KEYSTROKE DISPLAY

 0.