Calculated Industries 4065 v3.1 Pocket Reference Guide Advanced Consnruction-Math - Manual (Page 5)

P OCKET R EFERENCE G UIDE — 1
NOTE TO METRIC USERS
The factory-set Stored Values and
Preferences for the Construction Master
Pro are set in imperial values. You can
easily change these values to the metric
values you use in your work. These
values will be stored, even after the unit
has been powered off, until you do a
Clear All (Ç x), a Full Reset, or
change the batteries.
Below are the metric default values used
in the examples in this guide, along with
instructions on how to change them from
the imperial default values. Calculation
results shown in the guide have been
rounded. Your calculator’s LCD display
will give results with as many as six digits
to the right of the decimal.
STORED VALUES DEFAULT VALUE
Desired Riser Height
200
MM
Desired Tread Width
250
MM
Floor Height
250
MM
On-center Spacing
400
MM
(Cont'd)