Calculated Industries 4067 Pocket Reference Guide - Manual (Page 29)

27
* Height Above Plate. If a Top Plate value is shown when you want to enter a HAP, clear
the Top Plate value by pressing either O or 0 . Then, press e to move to the
HAP entry prompt and enter the desired value.
**Tail Length and Total Rafter Length shown only when Horizontal Overhang is entered.
eXaMPle: Enter an 8" Pitch, a 12′ Run, an 18" Overhang and 2-1/4" Total
Fascia Thickness:
1. Clear Calculator:
OOO
2. Start Advanced Rafter function:
Cr
3. Enter 8" Pitch:
8ie
4. Enter 12′ Run:
12fe
C
ontinued
►