Calculated Industries 4067 Pocket Reference Guide - Manual (Page 18)

16
Default Values
The table below shows the calculator’s U.S. and Metric Default Values.
Default Values can be changed by entering a new value. The new Default
Value will remain until you change it or reset it to zero. An All Clear
( Cx ) will reset values to the calculator’s Default Values.
Functions — U.S. Mode
Common Rafter
• Ridge Thickness 1-1/2"
• Rafter Width 7-1/4"
• Plate Width 3-1/2"
Jack Rafter
• O.C. Spacing 16"
• Rafter Thickness 1-1/2"
• Hip/V Thickness 1-1/2"
• Ridge Thickness 1-1/2"
Baluster/Open Baluster
• Maximum Spacing 4"
Hip/Valley
• Ridge Thickness 1-1/2"
Stairs
• Target Riser Height 7-1/2"
• Target Tread Width 10"
• Top Floor Thickness 10"
• Headroom Height 80"